Install the upgrade to a new volume using one of the following commands:.Navigate to the folder where you install software using the command: cd /shared/images.You must log in as root to perform this procedure. Use SSH to log in to the machine you want to upgrade.If you do not have a second volume, use the following procedure to install the upgrade for this machine:.If you selected a target volume, complete the remaining steps to finish the upgrade.Note: If the Target Volume list is empty, the machine you are upgrading does not have a second volume available for you to install the upgrade. Upgrade all managed BIG-IP devices to version 12.1 or laterįor you to manage BIG-IP devices from BIG-IQ Centralized Management, the BIG-IP devices must be running version 12.1 or later. You'll need to enter that IP address when you perform setup after you upgrade and reboot the BIG-IQ system. If you are currently using a self-IP address for device discovery, make a note of that IP address. Software volume for installing a new image or hotfix on the BIG-IQ If you don't have two volumes, refer to: K17406: Using the tmsh utility to create a new You must have at least two volumes to upgrade. Refer to the section titled,ĭecide which disk volume you want to install When addressing configuration conflicts for eachīIG-IP device, F5 recommends you use BIG-IP to override theĬonfiguration settings stored on BIG-IQ. Deploy any staged configuration changes toĭeploy configuration changes you have stagedįor your devices.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |